Self-Adhesive TENS Unit Electrodes Directions for Use:

Application:

• Clean skin thoroughly prior to each application of electrode pads. Electrodes do not stick well if any lotion, oil, make-up, dirt, etc. is left on skin.
• Insert the pins of the lead wire from the device into the electrode wire connectors.
• Remove the electrode pads from the protective liner and apply firmly to the skin. Adhesion improves when electrodes reach skin temperature.
• Helpful hint: Always moisten skin with a damp cloth with water prior to applying electrodes. This will improve the electrode adhesion and life.

Removal:

• Lift at the edge of electrodes and peel. Do not pull on the lead wires when removing electrodes from the release liner or skin. You may damage the electrodes if you do so.
• Place the electrodes on the liner and remove the lead wire by twisting and pulling at the same time.

Care and storage:

• Between uses, store the electrodes in the resealable bag in a cool, dry place.
• The life of the electrode pads varies depending on skin condition, storage, amount of use, type of satimulation, and stimulation site. Electrode life may be extended by carefully following the application instruction above.

Important:

• The electrodes are intended for single patient use only.
• Do not apply to broken skin. Should skin rash occur, discontinue use and contact your physician.
• Do not stimulate while driving a motorized vehicle, or operating machinery.
• Do not exceed 0.1 Watts/CM

Self-Adhesive TENS Unit Electrode Pad Placement

Please consult with your doctor as to where to place the electrodes to receive the pain relief results you desire from your TENS unit. ActiveForever does not have staff on hand that is authorized nor qualified to instruction regarding TENS Unit Electrode Placement.